Jam At Duplex: Jam D - Xerox Phaser 6360 Service Manual

Jam at Duplex: Jam D

Phaser 6300/6350/6360 Color Laser Printer Service Manual
The Duplex Jam Sensor indicates that paper did not reach the sensor on time
or that paper remains in the Chute Assembly Out.
Applicable Status Code:
Code 153: Jam at Duplex
Initial Actions:
■
Check for obstructions or debris in the Chute Assembly Out or paper
path.
■
Cycle printer power.
■ If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Duplex Jam Sensor, PL5.4.1
■
Jam Sensor Actuator, PL5.4.13
■
Duplex Motor Assembly,
■
PL5.4.5
FRONT/DUP Harness,
■
PL5.3.28
Chute Assembly Out, PL5.3.1
■
Troubleshooting Procedures Table
Step Action and Questions
1 Check the following for evidence of
fault or damage:
Duplex Motor Assembly, PL5.4.5
■
JAM Sensor Actuator, PL5.4.13
■
Chute Assembly Out, PL5.3.1
■
Are there any defects?
2 Test the Duplex Jam Sensor.
Run the Service Diagnostics Jam
Sensor test.
Does the sensor function correctly?
3 Check printer function.
Does the printer function correctly
after replacing the Duplex Jam
Sensor?
Check the Duplex Jam Sensor signal.
4
Block the Duplex Jam Sensor.
Is the voltage across J133-1 <=>
J133-2 0 V?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 1 P/J Locator (page 10-5)
■
Print Engine Drive Wiring Diagram (page 10-19)
■
Print Engine Paper Feed Wiring (page 10-26)
■
Yes
Replace any
damaged part.
Go to Step 7.
Complete
Go to Step 6.
No
Go to Step 2.
Replace the
Duplex Jam
Sensor and
Go to Step 3.
Go to Step 4.
Go to Step 5.
3-13