Xerox Phaser 6360 Service Manual page 116

Error Messages and Codes
3-16
Troubleshooting Procedure Table
Step Action and Questions
Check the following for damage.
1
Registration Sensor Actuator,
■
PL4.1.1
Registration Roller Assembly,
■
PL4.2.1
Is there any damage?
Test the Registration Sensor.
2
Run the Service Diagnostics
Registration Sensor test.
Does the sensor function correctly?
Check the Registration Sensor
3
connection.
Is the Registration Sensor connected
to the harness?
Check all pins on the REGISNS
4
Harness PL 4.1.4 for continuity.
1. Disconnect P/J181 and P/J18.
2. Check continuity between J181 <=>
J18.
5 Check the Registration Sensor signal.
Block the Registration Sensor.
Verify the voltage between P/J18-3
<=>
P/J18-2 on the Engine Control Board
is 0 VDC.
Test the Registration Clutch.
6
1. Close the Interlock Switch while
testing.
2. Run the Service Diagnostics
Registration Clutch test.
Does the clutch function correctly?
Check the Registration Clutch
7
resistance.
Disconnect connector P/J192.
Is the resistance between J192-1 <=>
J192-2 less than 200Ω?
Check for +24 V to the Registration
8
Clutch.
1. Disconnect P/J192.
2. Close the Interlock Switch while
testing.
Is there +24 V across P192-3 <=>
ground?
Yes
Clean or replace
as needed.
Go to Step 6.
Go to Step 4.
Go to Step 5.
Go to Step 6.
Go to Step 8.
Go to Step 8.
Replace the
Registration
Chute
(page 8-41).
Phaser 6300/6350/6360 Color Laser Printer Service Manual
No
Go to Step 2.
Go to Step 3.
Reconnect.
Replace the
Registration
Sensor Harness.
Replace the
Registration
Sensor
(page 8-39).
Go to Step 7.
Replace the
Registration
Clutch (Part of
the Registration
Roller Assembly)
Replace the
Engine Control
Board
(page 8-106).