Replace Transfer Roller Or; Transfer Roller Is At End Of Life - Xerox Phaser 6360 Service Manual

Replace Transfer Roller or

Transfer Roller Is at End of Life

Phaser 6300/6350/6360 Color Laser Printer Service Manual
The Toner Full Sensor indicates that the Transfer Roller requires replacement.
Applicable Status Code:
Code 206: Replace Transfer Roller
Warning: Transfer Roller is at End of Life
Initial Actions:
■
Print the Supplies Usage page to verify the remaining life and Transfer
Roller install date.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Note
Look at the clear plastic window on the Transfer Roller. If toner is present
in the center of the window, the Transfer Roller is at end of life and needs
to be replaced. If no toner is visible, try cleaning the CTD (ADC) Sensor.
The Transfer Roller is at End of Life is a warning. Replace Transfer Roller
is a hard stop.
Troubleshooting Reference Table
Applicable Parts
Toner Full Sensor, PL5.2.20
■
Transfer Roller, PL5.1.4
■
TNRFULL/FSR Harness,
■
PL5.2.30
Troubleshooting Procedure Table
Step Actions and Questions
Check the following for evidence of
1
fault or damage:
Transfer Roller PL5.1.4
■
Toner Full Sensor PL5.2.20
■
2 Test the Toner Full Sensor.
Run the Service Diagnostics Transfer
Roller Toner Full Sensor test.
Does the sensor function correctly?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 2 - P/J Locator (page 10-6)
■
Print Engine Wiring Xerographics (1/2)
■
(page 10-24)
Yes
Replace any
damaged parts.
Go to Step 5
No
Go to Step 2.
Go to Step 3.
3-37