Error Messages and Codes
Misfeed at Tray 4: Jam T4
3-26
Paper being fed from the 1100-Sheet Feeder did not reach the Registration
Sensor on time.
Applicable Status Code:
Code 158:
Feed Jam
Initial Actions:
■
Try picking paper from a different tray.
■
Ensure that Tray 4 is installed properly and the paper guides are set
correctly.
■
Remove, fan, and reload supported media in Tray 4.
■
Remove any obstructions or debris in the paper path and cycle printer
power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feed Rollers, PL12.5.18
■
Paper Pick Assembly, PL12.5.1
■
Drive Assembly, PL12.3.9
■
OPFDR Harness, PL12.3.7
■
OPTFDR Board, PL12.3.3
■
OPFREC2 Harness, PL12.3.1
■
Troubleshooting Procedure Table
Step Actions and Questions
1
Check the printer paper path.
Does paper feed correctly from Tray 2?
2
If possible, print a Test print from Tray 4.
Does the Drive Assembly operate?
Test the Drive Assembly.
3
Run the Service Diagnostics HCF/LTA
Motor test.
Does the Drive Motor function correctly?
4
Check for +24 V to the Drive Motor.
1. Disconnect P/J82.
2. Close the Interlock Switch while testing.
Is the voltage between P82-1 <=> ground
on the Upper Circuit Board HCF +24 V?
Wiring and Plug/Jack References
1100-Sheet Feeder P/J Locator (page 10-10)
■
1100-Sheet Feeder Tray Wiring (page 10-31)
■
1100-Sheet Feeder Drive Wiring (page 10-30)
■
Yes
Go to Step 2.
Go to Step 9.
Replace the
Engine Control
Board,
page 8-106.
Go to Step 7.
Phaser 6300/6350/6360 Color Laser Printer Service Manual
No
See "Misfeed at
Tray 2 Jam T2"
on page 3-20.
Go to Step 3.
Go to Step 4.
Go to Step 5.