Misfeed at Tray 1 (MPT): Jam T1
Phaser 6300/6350/6360 Color Laser Printer Service Manual
Paper fed from Tray 1 (MPT) did not reach the Registration Sensor on time.
Applicable Status Code:
Code 155:
Misfeed at Tray 1
Initial Actions:
■
Ensure that Tray 1(MPT) is securely attached to the printer.
■
Try picking paper from a different tray.
■
Check the paper path for obstructions or debris.
■
Ensure that the media guides are set correctly.
■
Cycle printer power.
■
If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Feed Roller Assembly MPT,
■
PL5.3.20
Interlock Switch, PL9.1.11
■
Registration Sensor, PL4.1.3
■
Feed Solenoid, PL5.3.9
■
Registration Roller Assembly,
■
PL4.2.1
Main Drive Assembly, PL8.1.2
■
Troubleshooting Procedure Table
Step Actions and Questions
1
Check the following for evidence of
fault or damage:
Feed Roller Assembly MPT,
■
PL5.3.20
Tray 1 (MPT)
■
Registration Sensor, PL4.1.3
■
Main Drive Assembly, PL8.1.2
■
Remove any foreign objects or paper
debris from the paper path.
Is there any damage?
Test the Registration Sensor.
2
Run the Service Diagnostics
Registration Sensor test.
Does the sensor function correctly?
Error Messages and Codes
Wiring and Plug/Jack References
Print Engine Map 1 P/J Locator (page 10-5)
■
Print Engine Power Wiring Diagram
■
(page 10-17)
Print Engine Drive Wiring Diagram
■
(page 10-19)
Print Engine Paper Feed Wiring
■
(page 10-26)
Yes
Replace any
damaged or
excessively worn
parts.
Go to Step 6.
No
Go to Step 2.
Go to Step 3.
3-17