Error Messages (Err; Additional Parameters For "001" System Errors And "002" System Warnings; B.2 Messages With Multiple Parameters - Christie CP2000-SB User Manual

B.2 Messages with Multiple Parameters

Certain messages are more complex and require multiple parameters in order to relay complete information.
These messages are described in detail below.
B.2.1 Error Messages (ERR)
An error message is generated by the projector/TPC, and contains a numerical error code, a message specifier
(i.e., type of error, such as "System Error"), and a text explanation of the error. In addition, "System
Error" and "System Warning" error messages also include further explanation of the nature of the error,
such as its location and cause. NOTE: The type of error and text parameters are enclosed together in
quotation marks, separated by a colon and space. In the table below, the text explanation appears as -----.
Table B.2 Error Messages
Error Code (P1)
001
002
003
004
005
006
007
008
009
010

Additional Parameters for "001" System Errors and "002" System Warnings

"System Error" and "System Warning" error messages include two additional parameters (P3 and P4), which
further describe the error. P3 indicates what component or system is involved (such as interlocks, fans,
temperature, SSM communication, or a lamp failure) and P4 relays the specific condition detected at the
suspect component, such an over-temperature reading or a slow fan speed reading-note these values indicate
temperature or fan speed only. See Table B.3, Table B.4, and Table B.5.
When a system error is resolved and is no longer present, another message reports this by replacing the first
digit in the original P3 error code with a "1".
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Type of Error (P2)
"System Error: -----"
"System Warning: -----"
"Invalid parameter-"
"Too many parameters"
"Too few parameters"
"Source does not exist"
"Could not be executed"
"Checksum error"
"Unknown request"
"Communication error"
Meaning
"System critical error.
"System error.
"Invalid parameter number.
"Message requires fewer parameters
"Message requires more parameters
"The source # is wrong
"Current content prevented the command from executing.
"The checksum is incorrect.
"Message code undefined. If the message sent as a command it is
ignored and no error is returned.
"Error receiving serial data on one of the RS-232 ports.
Section 1: Introduction
B-15