Christie CP2000-SB User Manual page 187

Section 1: Introduction
Function Code / Examples
User ID (UID)
(UID "JSMITH" "PassWord")
Virtual Network (VNC) requires v2.7 or higher and TPC 60/66
(VNC 1)
(VNC 0)
Zoom (ZOM) requires v2.9 or higher
(ZOM -1264)
(ZOM -1264 -1)
(ZOM! -1264 -1 1)
For single-parameter functions listed in Table B.1, you can determine the parameter's range with the request
message (ASCIICODE?M).
For example:
(LPL?M) What is the minimum and maximum lamp limit?
(LPL!M000 5000)Minimum lamp limit = 0, maximum lamp limit = 5000
If a function code has multiple parameters (see
be requested.
B-14
Description and Parameters
Allows remote access to a projector where a specific user name and
password is set up and required. NOTE: This command is only
necessary when the remote access setting in the projector is set to
login required.
P1 = User Name (e.g., JSMITH — case insensitive)
P2 = Password (e.g., PassWord — case insensitive)
Start VNC server NOTE: Should only be used for training
Reboots TPC
Changes the zoom setting of the lens under motor control.
Write
P1 = Location
P2 = Approach direction
NOTE: Approach is optional (-1 = Positive to Negative Approach,
1 = Negative to Position Approach)
Read
P1 = Real-time position
P2 = Current direction
P3 = Moving Status (0 = not moving, 1 = moving)
Related commands are Intelligent Lens System (ILS), Lens
Horizontal Offset (LHO), Lens Vertical Offset (LVO), and Focus
(FCS)
B.2 Messages with Multiple Parameters), their ranges cannot
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)