Lcd Error Messages - Christie J Series Service Manual

Section 3: Troubleshooting

3.4.4 LCD Error Messages

To receive more information about an error, send the following serial command, where "x" is the first number
in the error message: HTL+LSOL?x
For instance; if the LCD showed the following:
More information can be retrieved by the following serial command: HTL+LSOL?3
The projector would then respond with:
For more information about the HLT command, see the Serial Command (P/N: 020-100224-XX)
documentation, available on the Christie web site.
3-4
System Health
3:11 (Critical) Thermal Det: 4
HLT+LSOL!003 "Failed to assign I2C address to
Thermal Sensor. Verify Sensor Configuration
File. Detection Failure for Thermal Sensor.
Check cables and Configuration File."
Error Alarm
J Series 1000W and 1200W Service Manual
1/1
020-100725-04 Rev. 1 (07-2015)