Lcd Error Messages; Lcd Error Message List - Christie M Series Service Manual

• Email address
• A detailed description of the error
• A photo of the error (optional)
3. Send the email toChristie technical support.

LCD error messages

To receive more information about an error, send the following serial command, where x is the first
number in the error message: HLT+LSOL?x
For example, if the LCD displays the following:
System Health
3:11 (Critical) Thermal Det: 4
Retrieve more information with the HLT+LSOL?3 serial command. The projector responds with:
HLT+LSOL!003 "Failed to assign I2C address to Thermal Sensor. Verify Sensor
Configuration File. Detection Failure for Thermal Sensor. Check cables and
Configuration File.
For more information about the HLT command, see the M Series Serial API Commands Technical
Reference (P/N: 020-100224-XX) available on the Christie website.

LCD error message list

If the projector displays an error message not documented below or you cannot correct the issue
using the recommended procedure, contact Christie technical support.
Error message
Blue Bias
Blue Comm
Blue Offset
Blue Reset
Blue Therm
Boot Mode
DMD Mismatch
M Series Service Guide
020-100551-11 Rev. 1 (01-2019)
Copyright 2019 Christie Digital Systems USA, Inc. All rights reserved.
©
Error Alarm
Conditions
Blue bias under voltage
Blue satellite communication error
Blue offset under voltage
Blue reset under voltage
Blue DAD thermal shutdown
Engine unexpectedly in boot mode
with limited functionality
One DMD may be of a different
resolution
1/1
Replace the light engine.
• Check the blue satellite
communication cables for loose
connection.
• Cycle AC power.
Replace the light engine.
Replace the light engine.
Allow the projector to cool down.
• Re-install the projector
software.
• Cycle AC power.
• Replace the panel driver.
Replace the light engine.
Troubleshooting
30