Christie CP2000-SB User Manual page 181

Section 1: Introduction
Function Code / Examples
LampLOC™ Module (LLM)
(LLM000 000 0158)
Lamp Message Enable (LME)
(LME 0)
(LME 1)
Lamp Mode (LPM)
(LPM S101 2)
(LPM? G)
(LPM! G 002)
(LPM? S101)
(LPM! S101 003)
(LPM?)
(LPM! 2000)
Lamp Per Button (LPB)
(LPB O)
(LPB?)
(LPB! 1)
B-8
Description and Parameters
Single Parameter
1=Calibrate stepper motors
2=Automatic Lamp alignment (LampLOC™)
Multiple Parameter
P1 = 0 (move motor)
P2 = 0, 1, 2 (specifies either x, y, or z motor respectively)
P3 = Destination / new motor position (-200 up to +200)
Enables or disables a lamp timer message when the lamp has
exceeded its expected life.
0 = No lamp message will appear when lamp limit expires
1 = Lamp message will appear when lamp limit expires
2 = Constant power
3 = Constant light intensity (LiteLOC mode)
NOTES: 1) Specify desired channel with "S". If no "S" parameter
is included, the LPM setting will apply to the current channel when
the "Lamp Per Channel" checkbox is enabled, and to all channels
when the checkbox is cleared. 2) Specify global parameter with
"G".
Changes mode for channel 101 to constant power
Requests global power mode
Reply to global power mode request
Request for Chan 101 power mode
Reply to Chan 101 power mode request
If Lamp per channel, reply is channel power mode, otherwise
returns global power mode
0 = Off; Lamp settings will be the same for all channels.
1 = On; Lamp settings will vary according to channel.
NOTE: This setting determines whether lamp mode, power and
intensity are the SAME for every channel (i.e., global) or
DIFFERENT for each.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)