Christie CP2000-SB User Manual page 120

Source
Standard
SMPTE 295M-1997 (NOTE: Uses 1250 total lines per frame)
SMPTE 295 M
SMPTE 296M-2001
SMPTE 296M
SMPTE 260M-1999 (NOTE: This standard does not officially support 60/M)
SMPTE 260M
SMPTE 372M-2001 DUAL-LINK
All SMPTE 292m-1998 single-link formats (see above) are available as 12-bit 4: 4: 4 dual link, with the same
performance/format
NOTE: All sources shown are 10-BIT 4:2:2UNPACKED unless otherwise noted M = 1.001
* Signal must include 3:2 pull-down encoding and Ancillary Time code information.
* * Signal must include 2:2 pull-down encoding, and assumes field one (1) dominance. Same as Prog.
Segmented Frame.
* * * Image will be centered vertically on screen (default).
Keep in mind that the projector will attempt to automatically adapt to any incoming data format that does not
exceed either the bandwidth of the system or the frame rate limitations, thus formats beyond those shown
above may be compatible.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Orig. Format Vert. Freq.
1920 x 1080 50 Hz
1280 x 720 60 Hz
1280 x 720 59.94 Hz
1280 x 720 50 Hz
1280 x 720 30 Hz
1280 x 720 29.97 Hz
1280 x 720 25 Hz
1280 x 720 24 Hz
1280 x 720 23.98 Hz
1920 x 1035 60 Hz
1920 x 1035 59.94 Hz
Scan Type Display Format
(Progressive)
** Interlaced 1920 x 1080; 25 Hz
Progressive *** 1673 x 941; 60 Hz;
Progressive
Progressive *** 1673 x 941; 59.94 Hz;
Progressive
Progressive 1920 x 1080; 50 Hz
Progressive 1920 x 1080; 30 Hz
Progressive 1920 x 1080; 29.97 Hz
Progressive 1920 x 1080; 25 Hz
Progressive 1920 x 1080; 24 Hz
Progressive 1920 x 1080; 23.98 Hz
* Interlaced 1920 x 1080; 24 Hz
* Interlaced 1920 x 1080; 23.98 Hz
Section 1: Introduction
4-3