Christie CP2000-SB User Manual page 23

Section 1: Introduction
6. Route the NEGATIVE (–) BLACK lamp lead through the hole in the cooling compartment floor (Fig-
ure 2-11). The igniter wires from terminal 5 and the PCB are also routed here.
7. A universal connector nut should be pre-installed on the cathode-end
lamp post. Regardless of model or lamp size, this nut is 1.658" in overall
length. See right. NOTE: The universal nut shown accommodates all
models. Do not install a shorter nut. Important! Ball joint must move
freely. If necessary, hand tighten with 9/64" Allen key.
8. With 3/16" Allen key, secure the
side of the connector nut. Important! Secure lamp lead FIRST on connector, then remaining two igniter
wires on TOP.
At this point, the lamp pre-wiring is complete. Leave lamp accessible for now.
2-8
Figure 2-11 Feed Black Lead
into Compartment
NEGATIVE (–) BLACK
Figure 2-13 Secure Lamp
Lead and Two Igniter Wires
Figure 2-12 Connector Nut
lamp lead and the two igniter harnesses to the
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)