Custom: Lamp Menu - Christie CP2000-SB User Manual

Custom: Lamp Menu

This menu provides controls for maintaining consistent light output over time or setting a precise power level
for the lamp. As shown in Figure 3-13, the Custom: Lamp menu provides controls for maintaining a specific
light output over time (LiteLOC™) or setting a precise power level for the lamp.
Current Channel #.
Toggle LiteLOC™
function ON/OFF.
Set and maintain
consistent light output
as indicated in the Set
light level window.
Lamp power range
adjustable from 75% to
110% if LiteLOC™ is not
in use (or as temporary
override).
Table 3.7 Summary of Custom: Lamp Menu Options
CUSTOM: LAMP MENU OPTIONS
Lamp Per Channel
Enable
Lamp Power
Set
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Apply LiteLOC™ settings to the
current channel only (checked).
Figure 3-13 Custom: Lamp Menu Options
™
When enabled, LiteLOC setting is applied to the specified channel. When disabled, all channels
™
will use the global LiteLOC
Maintains a chosen light level at the screen over time - the lamp ballast will gradually increase power
to the lamp as necessary, until it reaches the maximum level possible for the installed lamp. To disable
™
LiteLOC temporarily or permanently, clear the LiteLOC
Power directly.
Indicates what percentage of power (appropriate for the installed lamp) to supply to the lamp, auto-
matically overriding any LiteLOC
™
fall, but the LiteLOC line and set value will not change unless Set is pressed (defining a new
™
LiteLOC setting). See Table 8.1 Minimum and Maximum Lamp Power by Lamp Type, on
page 8-6 for lamp power ranges.
With the desired light output measured at the screen, press Set to automatically enable LiteLOC
The current brightness level will be maintained as long as possible. NOTE: Arbitrary units shown
here, not footlamberts or lumens.
Display of current lamp
settings - automatically
updated; read only.
setting.
™
™
setting that may be in effect. This causes the bar graph to rise or
Section 1: Introduction
Reading from light
sensor.
Light Output (sensor
reading); read only.
Enable checkbox or adjust Lamp
™
.
3-25