Christie CP2000-SB User Manual page 35

Section 1: Introduction
In rare cases where additional tilt is needed, you can utilize the rear extender legs as described below.
Important! For best optical performance, avoid tilting the projector excessively. Use vertical offset of the
lens instead.
3. Remove the rear bottom panel (2 top screws, 2 bottom tabs) from the CP pedestal (Figure 2-30).
4. Use a low-profile scissor jack to elevate the rear of the projector.
5. On each side of the rear opening in the pedestal, loosen the 2 bolts securing the rear extender legs to the
projector (Figure 2-31).
6. Slide the legs out to the desired position and secure with two bolts.
7. Remove the jack.
8. If necessary, re-adjust all leveling feet for side-to-side leveling (Figure 2-29). Note that you may have to
adjust level more precisely once an image is present.
2-20
Figure 2-30 Open Rear of Pedestal
Figure 2-31 Adjust Rear Extender Legs
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)