Christie CP2000-SB User Manual page 186

Function Code / Examples
Simple Network Management (SNM) requires v2.7 or higher and TPC 60/66
(SNM 0 "trap IP address")
(SNM 1 OID)
Select Source Format (SRF)
(SRF "filename")
(SRF?)
(SRF!"1280x1024square")
Shutter Control (SHU)
(SHU 0)
(SHU 1)
Source Change (SRC)
Stop TI Communication / Terminate TPC Application (STP)
System Status (SST)
Target Color Gamut (TCG)
(TCG "filename")
(TCG?)
(TCG!P7V2)
3D Controls (TDC)
(TDC 1)
(TDC 10 420)
Time & Date (TMD)
(TMD 2003 08 13 14 21 00)
(TMD! 2003 08 13 14 21 00)
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Description and Parameters
Used for simple network management protocol setup
To disable specify "0.0.0.0"
OID is either 11273 or 25766
Select the stored source file defining incoming resolution and
desired aspect ratio for the current display.
What is the current source format?
Current source format filename is 1280x1024square.
Open or close the electronic "quick douser"
0 = shutter open
1 = shutter closed
Same as CHA command
0 = Start TI communication
1 = Stop TI communication
2 = Terminate TPC application
3 = Reboot TPC
Method of reading projector information. See Messages With
Multiple Parameters later in this Appendix.
Select the stored target color gamut file to apply to the current
display.
What TCGD is currently in use?
The P7V2 TCGD is in use
Turn 3D controls ON/OFF or sets specific 3D controls
Example shown: Set dark time to 420μs
For all other 3D controls, see Messages With Multiple Parameters
later in this Appendix.
Set/read the time and date in the projector's real-time clock.
P1 = Year (yyyy)
P2 = Month (01-12)
P3 = Date (1-31, day of month)
P4 = Hour (0-23, 24hr clock)
P5 = Minute (0-59)
P6 = Second (0-59)
Section 1: Introduction
B-13