Examples Of Ils Commands; System Status (Sst - Christie CP2000-SB User Manual

Examples of ILS Commands

ILS Command
(ILS 0 1)
(ILS 1 1)
(ILS 2 1)
(ILS 3)
(ILS 4)
(ILS 10 1023 -264 800 -1248)
(ILS 10 1023 -264 800 -1248 - 1 1 1 -1)
B.2.5 System Status (SST)
The SST message provides a variety of information about the current state of the projector. The single broad-
ranging request (SST?) for all information triggers the return of a series of replies as if multiple requests had
been sent. In each of these replies, P1 explains the general content or topic of that reply, and P2 the individual
details. To obtain status for one topic only, specify the desired P1 parameter corresponding to that topic-for
example, the request (SST?0) will trigger general projector information only. For a specific single-status
inquiry, include both P1 and P2 in the request-for example, (SST?4 3) asks what version of SSM main
software is installed.
Table B.6 System Status Messages
P1
If P1 = 0
General Projector
Configuration
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Sets ILS installed to Yes
Sets Lens Reset on Startup to Yes
Sets AutoILS to Yes
Invokes Lens Calibration
Invokes Lens Reset
Moves all four motors to the specified offset, focus and zoom locations.
Approach goes from negative to positive.
Moves all four motors to the specified offset, focus and zoom locations.
Approach is specified for all four motors.
P2
0 = Model
1 = Serial Number
2 = Build Date
3 = Native Resolution
4 = N/A
5 = Lamp Power/Lamp Type
6 = Lamp Ballast I.D. (v 2.4c and up)
7 = Interface Board Serial #
8 = Processor Board Serial #
9 = Processor Board Type
10 = Interface Board Type
11 = Formatter Interface Type
12 = Formatter Board Type
13 = TPC Type
14 = ILS Board Serial Number
Section 1: Introduction
Result
Notes
B-19