Tpc Status: Diag Menu; Tpc Status: Interrogator Menu - Christie CP2000-SB User Manual

Section 1: Introduction

3.11.2 TPC Status: Diag Menu

The Status: Diag menu provides status information about projector components and the current cinema source,
and enables log files for each device to be saved to the TPC's storage card for diagnostics.
Info about
projector
components.
Clear SMPTE
errors. Useful for
testing if they
recur.
SMPTE log of
source (server)
errors.

3.11.3 TPC Status: Interrogator Menu

The password-protected Status: Interrogator screen
enables the collection of advanced-level status
information that can assist in the diagnostics of
projector components. Interrogator can be run in two
modes and enables the collection of log files only
(BASIC MODE) or log files plus registered batch files
(ENHANCED MODE). These files are then stored on
the TPC's storage card. For Interrogator to
successfully retrieve these diagnostic files, the
projector must remain in its failed state (with
incorrectly displayed image on screen).
NOTES: 1) Always run Interrogator first before
power cycling the projector, otherwise important
diagnostic files will be unusable. 2) Never run
Interrogator during a show as this could cause image
disruption. 3) Interrogator is also accessible through
a separate login and password (different from the service login). Contact Christie tech support for assistance
and password.
3-72
Figure 3-61 Status: Diag Menu Options
Write SMPTE log
to TPC's storage
card directory.
Write projector
log or self test
log to TPC's
storage card
directory.
Test every
projector
component.
NOTE: Do not
use during a
show.
Reboot and per-
form a Self Test.
NOTE: Password - protected
Figure 3-62 Status: Interrogator Menu Options
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)