Controls (Tdc - Christie CP2000-SB User Manual

Section 1: Introduction
P1
If P1 = 5
Self Test
B.2.6 3D Controls (TDC)
A number of 3D controls enable setup and adjustment of incoming 3D source material. Parameter P1 activates
the specific control, and P2 sets the desired adjustment.
0 = Disable 3D
1 = Enable 3D
2 = Frame Rate Multiplication
3 = L/R Input Reference
B-22
P2
70 = FFIB Main
71 = FFIB Boot
72 = FFIB FPGA Main
73 = FFIB FPGA Boot
74 = FFIB Startup FPGA
75 = FFIB Satellite FPGA
76 = FFIB Sequence Data
77 = FFIB DMD Data
0 = Interface Board
1 = Processor Board
2 = N/A
3 = System Supervisor Module (SSM)
4 = ILS Motor Control
10 = Space remaining on TPC? IPSM
11 = Space remaining on TPC Storage Card
12 = Space remaining in TPC memory
P1
n/a
n/a
If L/R input reference is 0, 1, 4, 5, 6, or 7 (rare):
0 = 4:1
1 = 5:1
2 = 6:1
If L/R input reference is 2 or 3 (typical):
0 = 4:2
1 = 5:2
2 = 6:2
Use number directly
11=1:1
21=2:1
...
61=6:1
22=2:2
...
62=6:2
0 = Use assigned GPI (true polarity)
1 = Use assigned GPI (inverted polarity)
2 = Left on Port A, Right on Port B
3 = Left on Port B, Right on Port A
4 = White Line Code (true polarity)
5 = White Line Code (inverted polarity)
6 = Blue Line Code (true polarity)
7 = Blue Line Code (inverted polarity)
Notes
For any test, 0=OK, 1=failed
0 = Ok, Non-zero = failed
KB
KB
KB
P2
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)