P3 Codes For “001” System Error Messages” - Christie CP2000 User Manual

ASCII MESSAGES
B-8
Error Code (P1) Type of Error (P2)
001 "System Error: -----"
002 "System Warning: -----"
003 "Invalid parameter—"
004 "Too many parameters"
005 "Too few parameters"
006 "Source does not exist"
007 "Could not be
executed"
008 "Checksum error"
009 "Unknown request"
010 "Communication error"
Additional Parameters for "001" System Errors and "002"System
Warnings
"System Error" and "System Warning" error messages include two additional
parameters (P3 and P4), which further describe the error. P3 indicates what
component or system is involved (such as interlocks, fans, temperature, SSM
communication, or a lamp failure) and P4 relays the specific condition detected at the
suspect component, such an over-temperature reading or a slow fan speed reading—
note these values indicate temperature or fan speed only. See Table B3, B4, and B.5
below.
When a system error is resolved and is no longer present, another message reports
this by replacing the first digit in the original P3 error code with a "1".
Table B.3. P3 Codes for "001" System Error Messages"
Component Code (P3)
1
2
3
4
5
8
9
10
11
12
16
17
18
19
20
21
22
32
33
35
36
48
48
System critical error.
System error.
Invalid parameter number.
Message requires fewer parameters
Message requires more parameters
The source# is wrong
Current content prevented the command
from executing.
The checksum is incorrect.
Message code undefined. If the message
sent as a command it is ignored and no
error is returned.
Error receiving serial data on one of the RS-
232 ports.
Interlock, Lamp Fan
Interlock, Extractor
(exit duct to outside world)
Interlock, Lamp Door Open
Interlock, Auxiliary
Interlock, Card Cage Tamper Interlock
Fan, Intake 1
(non-operator's side of projection head)
Fan, Intake 2
(non-operator's side of projection head)
Fan, Card Cage
Fan, LAD
(laminar airflow device near light engine)
Fan, Ballast
Prism Over temperature
DMD Red Over temperature
DMD Blue Over temperature
Integrator Over temperature
SSM
(System Supervisor Module)
Card Cage Over temperature
Ballast Over temperature
Lamp Life Expired
Lamp Failed to Strike
Unexpected Lamp Failure / Off
Reading Lamp Intensity Failed
SSM, Communication Failure
SSM, Upgrade Failed
Meaning
Component
Over temperature
(System Supervisor Module)
LIT MAN USR CP2000
020-100032-04 Rev. 1 (03/14)