Inputs; Cinema Inputs; Non-Cinema Dvi Inputs (For Alternative Content); Control Ports - Christie CP2000-SB User Manual

OPT. AUXILIARY LENSES **
1.25x Anamorphic
(for 2.39:1 scope screen)
1.26x Wide Converter
(for 2.39:1 scope screen)
Motorized Auxiliary Lens Mount
*Maximum offsets are reduced when simultaneously offsetting horizontally and vertically
** Auxiliary lenses install in the auxiliary adapter (optional) and are used in conjunction with a primary lens.
8.3

Inputs

8.3.1 Cinema Inputs

Number of inputs
Standard supported
Connector Type
NOTE: Currently supported cinema formats are listed in Table 4.1 on page 2.

8.3.2 Non-Cinema DVI Inputs (for Alternative Content)

Number of inputs
Standard supported
Connector Type
NOTE: Currently supported DVI formats (i.e., non-cinema formats) are listed in Table 5.1 on page 2.

8.3.3 Control Ports

RS-232 connectors (2): 9-pin D female
Ethernet connector (1): RJ-45 female
GPIO connector (1): 37-pin D female
Ballast Control Port (1): 9-pin D male (not a
user port)
Ballast Interlock Port (1): 9-pin D female (not
a user port)
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
PART #
38-809054-51
108-281101-01
108-111102-xx
2
SMPTE 292M bit-serial
BNC
2
VESA Digital Visual Interface (DVI-D)
24-pin female DVI-D
A= Non-ASCII PC communication B=Christie-propri-
etary accessories only
Stnd. 100 base-TX, 100 Mbps max.
RS-232, w/proprietary protocol
+5V TTL-compatible, opto-isolated at ballast end
MAX. % OF IMAGE OFFSET
FROMS LENS CENTER
n/a (determined by primary lens)
n/a (determined by primary lens)
n/a (determined by primary lens)
Section 1: Introduction
8-3