Christie CP2000-SB User Manual page 179

Section 1: Introduction
Function Code / Examples
GPIO Assignments (GIO) requires v2.7 or higher
(GIO i3 l "LampOff")
(GIO i3 h "LampOn")
(GIO ? I3H)
(GIO ? I3h "lampon")
(GIO ? I3L)
(GIO ? I3l "lampoff")
(GIO o3 "SystemHealth")
(GIO? o3)
(GIO! o3 "System Health")
Image Scaling Enable/Disable (IMS)
(IMS 0)
Intelligent Lens System (ILS) requires v2.9 or higher
Internal Test Pattern (ITP)
(ITP "RGB-12Bbit-Split Ramp")
(ITP"")
B-6
Description and Parameters
Allows macros to be assigned to GPIs and GPOs.
Important! Changing to a 3D channel with GPIO usage will
permanently delete the macro assignments for those GPIOs;
therefore, it is suggested that those GPIOs used for 3D channels
not be used for macros.
P1 = input # (1-5) or output # (1-5)
P2 = "Macro Name"
Predefined GPI macros:
"LampOn"
"LampOff"
"DouserOpen"
"DouserClosed"
"AuxLensIn"
"AuxLensOut"
"Channel 101" through "Channel 116"
Predefined GPO macros:
"System Health"
"Lamp State"
"Douser State"
"Auxiliary Lens State"
Enables or disable image scaling
0 = disable
1 = enable
Method of reading and writing ILS information. See
Intelligent Lens System (ILS)
Enter "test pattern filename" to display pattern.
Enter "" to turn off the test pattern.
Section B.2.4
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)