Christie CP2000-SB User Manual page 184

Function Code / Examples
Power (PWR)
(PWR 0)
(PWR 1)
(PWR! 000)
(PWR! 001)
Processing Mode (PRM)
(PRM 0)
(PRM?)
(PRM!001)
Projector Address (ADR)
(ADR "192.168.206.10")
(ADR?)
(ADR!"192.168.206.10")
Projector Configuration File (PCF)
(PCF "TPC1")
(PCF?)
(PCF! "TPC1")
Projector Hours of Use (PJH)
(PJH?)
(PJH!5672)
Projector Rental Hours (PRH)
(PRH?)
(PRH!1251)
Pull-Down Offset (PDO) requires v2.7 or higher
(PDO 2)
(PDO?)
(PDO! 002)
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Description and Parameters
Turn the lamp projector OFF or ON (0=off, 1=on).
Turn the projector (lamp) OFF
Turn the projector (lamp) ON
The projector (lamp) is OFF
The projector (lamp) is ON
Current processing of incoming source data.
0 = non-cinema only
1 = full cinema processing path
What is the current processing path?
Cinema processing path is currently in effect
Sets which projector—identified by its network address—will be
controlled by the TPC upon the next re-boot. Examples might
include 192.168.206.10 or 192.168.206.11, etc. Valid IP addresses
depend on the site.
Which projector (I.P. address) is controlled by the TPC?
Projector 192.168.206.10 is controlled by the TPC.
Use this pre-defined projector configuration file (PCF "filename")
for processing. This file contains TCGD, CSC, LUT-AL, LUT-
DG, LUT-CLUT, and SOURCE information.
What pre-defined processing file is currently in effect?
The TPC1 pre-defined proj. configuration file is in use
The number of hours that the projector has been used (incl. standby
and without a lamp)
How many hours have been logged on the projector?
Maximum=16,777,215 hours
How long has the projector been running with the lamp on?
Proj. has run 1251 hours with the lamp on
0= field offset to 1
1= field offset to 2
2 = field offset to 3
3 = field offset to 4
4 = field offset to 5
Request field offset
Response indicating field 3 offset
Section 1: Introduction
B-11