Initial Power Up - Christie CP2000-SB User Manual

2.5

Initial Power Up

STEP 1 - Turn on Breakers
With all components installed and connected, power-up the projector as described in Steps 1 and 2 in
3.2 Power-up Procedure. Do not ignite the lamp yet.
Important! Do not ignite the lamp until you have defined the lamp type in Step 6 below.
STEP 2 - Fill Reservoir a Second Time
NOTE: Disconnect the projector from AC power before filling the
reservoir.
Upon initial power up, the first supply of coolant you added will
drain into the hoses and fill them leaving the reservoir practically
empty. Using Christie approved coolant Jeffcool E105 provided in
the liquid coolant fill service kit (P/N 003-001837-02), re-fill the
reservoir until the level is close to but not above the top mark on the
gauge located on the outside of the pedestal door (Figure 2-32). If
you over-fill, remove the reservoir from the pedestal and pour out
excess.
STEP 3 - Power Down and Up Again
Turn all projector breakers OFF, then ON again to clear air from lines.
STEP 4 - Check for Airlock in Cooling System
After topping up the coolant reservoir, ensure the hose between the reservoir to the pump is completely full
upon the next power-up (Figure 2-33). NOTE: If the hose is not full, this signifies the presence of an airlock
that can interfere with proper circulation of the liquid throughout the projector. Turn the projector OFF then
ON once again. The hose should now be completely filled.
STEP 5 - Check Fans and Interlocks
Check that fans are running and interlocks are OK.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Figure 2-33 Check Hose for Airlock
Section 1: Introduction
Figure 2-32 Re-fill and Check Level
Section
2-21