Custom: Page-1 Menu - Christie CP2000-SB User Manual

Custom: Page-1 Menu

As shown in Figure 3-8 and Figure 3-9, clearing or checking the Use PCF checkbox determines which
Custom settings are available for use.
ID for current
custom settings.
Appears on Main
menu.
Source connection/
location.
Packing mode and #
bits of your source.
USE A PCF OR NOT? The availability of functions in the Custom menu depends on whether you choose to
utilize pre-defined configuration files (PCFs) already downloaded to projector memory (Figure 3-8), or
whether you prefer to implement your own settings from within the Custom menu. Although pre-defined
PCFs were originally intended as part of content from the distributor so that the intended image quality is not
compromised, this practice is rare. Instead, PCFs may be created using DCP Librarian and downloaded to the
projector. Most applications such as cinema, post production and alternative or non-cinema displays require
that one or more display parameters be individually adjusted-clear the Use PCF checkbox.
Source resolution
aspect ratio and off-
set. Choices defined by
installer or administra-
tor.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Always select for cinema sources.
Icon for current setup.
Use full cinema processing & scaling.
Click to change.
Use for all cinema sources, plus DVI
sources with vertical freq. 60Hz or
lower.
Figure 3-8 Custom: Page 1 Menu - Using
Pre-defined Configurations
Always select for cinema
sources.
Use full cinema processing
& scaling. Use for all cinema
sources, plus DVI sources 60
Hz or lower.
Figure 3-9 Custom: Page 1 Menu - Creating
Customer PCFs and Other Settings
Section 1: Introduction
Use pre-defined PCF.
Refresh/Update - Refresh
all selection lists
available in Custom
Menu.
3D is in use (3D Control
Menu).
Clear 1 or more channels
(restore factory defaults).
Native color reference.
(Choices defined by
installer. Default =
OnSite). PCF list replaces
Color Space, Gamma, LUT-
CLUT, Target Color and
Source options.
(List is configured by
installer or administrator).
Adjust Color Space, Gamma, LUT-CLUT,
Target Color & Source if cleared.
• Always de-select for cinema source.
• Always select to apply custom settings
defined as a PCF using DCP Librarian.
Refresh / Update - Refresh all
selection lists available in
Custom menu.
Clear 1 or more channels -
Restore factory defaults.
Applies custom color
processing - Choices defined
by installer. Default=P7V2 The-
atre.
Type of color decoding such as
RGB or YCbCr.
Type of gamma correction such
as PL2.6.
3-19