Ac/Power Precautions; Lamp Precautions - Christie CP2000-SB User Manual

6.1.3 AC/Power Precautions

Installation of this projector requires that an electrician hard-wire a 3-phase (Y) feed and a separate 15A
single-phase feed from the pedestal toe to the AC supply in your building. You must also use only the correct
pedestal for your geographic area as stated in
Operate the projector at the specified voltage. Warning! Do not attempt operation if the AC supply and
pedestal are not within the specified voltage range.
Do not allow anything to rest on the power cord. Locate the projector where the cord cannot be abused by
persons walking on it or objects rolling over it. Never operate the projector if the power cable appears damaged
in any way. Do not overload power outlets and extension cords as this can result in fire or shock hazards.
NOTE: Only qualified service technicians are permitted to open any enclosure on the product, and only if AC
has been fully disconnected at BOTH wall breakers. Warning! SHOCK HAZARD. Disconnect from AC
before opening any enclosure. Disconnect at BOTH wall breakers.

6.1.4 Lamp Precautions

Any Xenon arc lamp used in the CP2000-SB is under high pressure and must be handled with great care at all
times. Lamps may explode if dropped or mishandled.
WEAR PROTECTIVE CLOTHING:
Never open the lamp door unless you are wearing authorized protective clothing such as that included in a
Christie Protective Clothing Safety Kit P/N 598900-095. Recommended protective clothing includes-but may
not be limited to-protective gloves, latex lab gloves, double-layer 0.040" acetate face shield, and a quilted
ballistic nylon jacket or a welder's jacket. Warning! 1) EXPLOSION HAZARD -Wear authorized protective
clothing whenever the lamp door is open! 2) Never attempt to remove the lamp directly after use. The lamp is
under increased pressure when hot and may explode, causing personal injury and/or property damage. Allow
to cool completely.
NOTES: 1) Christie's protective clothing recommendations are subject to change. 2) Any local or federal
specifications take precedence over Christie recommendations.
COOL THE LAMP COMPLETELY:
The arc lamp operates at a very high pressure that increases with temperature. Failure to allow the
lamp to sufficiently cool prior to handling increases the potential for an explosion causing personal
injury and/or property damage. After turning the lamp OFF, it is crucial that you wait at least 10
minutes before turning off the rest of the projector breakers, disconnecting AC and opening the
lamp door. This provides enough time for the internal lamp cooling fans to properly cool the lamp. Cool
completely before handling. Again, always wear protective clothing! Warning! 1) Never attempt to access
the lamp while the lamp is on. Wait at least 10 min. after lamp shut-off before powering down, disconnecting
from AC and opening the lamp door. 2) SHOCK HAZARD. Disconnect from AC at BOTH wall breakers before
opening the lamphouse. For all other precautions critical for safe removal and replacement of the lamp, refer to
Section 6.4 Replacing the Lamp & Filter.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Section 1.2.2 Software Requirements.
Section 1: Introduction
6-3