Christie CP2000-SB User Manual page 182

Function Code / Examples
Lamp Power (LPP)
(LPP 2000)
(LPP?)
(LPP!2000)
(LPP S101 2)
(LPP? G)
(LPP! G 1608)
(LPP? S101)
(LPP! S101 2000)
(LPP?)
(LPP! 2000)
Lens Auxiliary (LNA) requires v2.7 or high
(LNA "1.25AN" "1234567")
Lens Horizontal Offset (LHO) requires v2.9 or higher
(LHO 1023)
(LHO 1023 -1)
(LHO! 1023 -1 0)
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Description and Parameters
Specific power setting for the lamp in Watts
Value Range = depends on the installed lamp
NOTE: Specify desired channel with "S". If no "S" parameter is
included, the LPP setting will apply to the current channel when
the "Lamp Per Channel" checkbox is enabled, and to all channels
when the checkbox is cleared.
Changes power value for channel 101 to 2000
Requests global power value
Reply to global power request
Request for Chan 101 power value
Reply to Chan 101 power request
If Lamp per channel, reply is channel power, otherwise returns
global intensity
P1 = Lens type
Valid lens = "1.25 AN" or "1.25WC"
P2 = Lens serial number
Adjusts the horizontal offset of the output lens under motor control.
Write
P1 = Location
P2 = Approach direction
NOTE: Approach is optional.
(-1 = Positive to Negative Approach,
1 = Negative to Position Approach)
Read
P1 = Real-time position
P2 = Current direction
P3 = Moving Status (0 = not moving, 1 = moving)
Related commands are Intelligent Lens System (ILS), Lens
Vertical Offset (LVO), Focus (FCS) and Zoom (ZOM)
Section 1: Introduction
B-9