Christie CP2000-SB User Manual page 180

Function Code / Examples
Lamp Changed (LPC)
(LPC "60123456" 100 "CDXL-20"
"Ignition Difficulty") or (LPC
"60123456" 100 "CDXL-20" 3)
Lamp History (HIS)
(HIS! 021 00001 "1234567" 00007 "2007/
08/01 15:58" "Other-20" 00000 00000
00000 000 "Usage Hours Exceeded")
Lamp Hours of Use (LPH)
(LPH 0528)
Lamp Hours Limit (LPL)
(LPL 750)
Lamp Intensity (LPI)
(LPI 12345)
(LPI?)
(LPI?s101)
(LP1!12345)
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Description and Parameters
Records the serial number, hours logged on lamp, lamp type and
reason for change of the newly installed lamp, thus resetting the
lamp time to "0" for logging time. Serial number = 32 characters
max.
Valid Lamp Types
CDXL-20
CDXL-30
CDXL-45
CDXL-60
CXL-20
CXL-30
CXL-45
CXL 60
Other-16
Etc.
Valid Change Reason (can be sent as number or text)
0 = ""
1 = "Usage Hours Exceeded
2 = "Light Level too Low"
3 = "Ignition Difficulty"
4 = "Light Unstable (flicker)"
5 = "Was Temporary Lamp"
6 = "Lamp Type Change"
7 = "Other"
Lamp history describes lamps used in the projector. See Messages
With Multiple Parameters in this Appendix.
The # hours logged on the current lamp (0-9999).
The # hours that a lamp can be used before a warning message
appears. Range=0-20000 hours.
The light output level chosen for LiteLOC. Same intensity for
every channel requires LPB (Lamp Per Button) set to "OFF".
NOTE: Specify desired channel with "S". If no "S" parameter is
included, the LPI setting will apply to the current channel when the
"Lamp Per Channel" checkbox is enabled, and to all channels
when the checkbox is cleared.
What is the current LiteLOC setting for this channel?
What is the LiteLOC setting for Channel 101?
The current LiteLOC setting is 12345
Section 1: Introduction
B-7