Custom: Lens Menu - Christie CP2000-SB User Manual

Section 1: Introduction

Custom: Lens Menu

This menu is used to modify the Intelligent Lens System settings for a particular channel. Adjust the Focus,
Horizontal (X) and Vertical (Y) Offset, or Zoom by clicking the respective buttons in a step-wise manner or
holding the button down for continuous movement. You may experience a slight delay in the response rate of
the lens upon selecting the buttons. Position values on the menu will change in real-time. When holding down
a button for continuous movement, the lens will begin to accelerate until the maximum velocity is reached.
NOTES: 1) Manual adjustments of the lens is for temporary use and will be lost once a channel is changed. 2)
This menu is for advanced users only. 3) Keep clear of rotating parts. Remotely operated motors may start to
spin without warning. 4) Avoid long hair, jewelry, and loose clothing exposure to the knobs during manual
adjustment. 5) In case of emergency, unplug the line cord to immediately halt movement of the lens mount.
the MALM to the OUT position before performing any lens calibrate or reset functions on the
Motorized Primary Lens Mount to prevent collision between the projection lens and the
MALM. 2) Hazardous moving parts. Keep fingers and other body parts away.
To adjust ILS settings for a particular channel:
1. Select a channel from the drop-down list.
2. Use the designated buttons to adjust Focus, Horizontal (X) and Vertical (Y) Offset, and Zoom.
Copy ILS settings to another channel:
To easily copy the settings from the current active channel to another channel, use the Copy Lens Settings to
Channel feature. Select the channel from the drop-down list and click Copy to apply the changes.
Use the buttons to adjust
the Offset.
Focus: Use the buttons
to adjust the focus.
Use this feature to copy
specific lens settings
over to multiple
channels.
Table 3.8 Summary of Custom: Lens Menu Options
CUSTOM: LENS MENU OPTIONS
Focus
Offset
Zoom
Copy Lens Settings
to Channel
3-26
1) If the Motorized Auxiliary Lens Mount (MALM) is present, ensure to move
Figure 3-14 Custom: Lens Menu Options
Click the buttons to automatically adjust the focus.
Click the up/down/left/right buttons to adjust the image and make it square on the screen.
Click the buttons to automatically minimize or maximize zoom.
Use the drop-down menu to select a particular channel and click Copy for the changes to affect the
selected channel. Repeat for every channel that requires the same ILS values.
Minimize/maximize
zoom.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)