Selecting The Cinema Source; Touch Panel Controller Method - Christie CP2000-SB User Manual

4.3

Selecting the Cinema Source

NOTE: For details regarding all TPC functions, refer to

4.3.1 Touch Panel Controller Method

As described in
configured so that any user can correctly display a desired feature simply by selecting the corresponding button
on either page of the Main menu displayed by the Touch Panel Controller. There are a maximum of 32
different display buttons available at any one time (8 per page), with most users locked out of other processing
controls available in other Touch Panel Controller menus. For cinema sources in particular, which are
displayed according to strict parameters pre-defined by the producers of the feature and implemented in the
projector by a CP2000-SB installer, administrator or trained operator, this simplicity ensures that the intended
display can be selected quickly and easily by any user.
To change to a new feature, do the following:
• Ensure the CP2000-SB and TPC are both powered up and operating normally.
• On the Touch Panel Controller, select the Main menu tab.
• On the Main menu page 1 or 2, press the desired display button-the image will update according to the many
display parameters defined for this source.
Refer to Section 3.5 Using the Touch Panel Controller (TPC)
1. Select pre-defined
source (large button).
2. Image will change.
NOTES: 1) Depending on your expected needs, your installer may or may not have configured all buttons for
use. 2) Buttons may have any icon or text.
CP2000-SB User Manual
020-100162-06 Rev. 1 (03-2014)
Section 3.5 Using the Touch Panel Controller
Figure 4-6 Select the Desired Source
Section 3.5 Using the Touch Panel Controller
(TPC), CP2000-SB displays are usually pre-
for other operating details.
Section 1: Introduction
(TPC).
To additional
sources.
4-7