Monitoring The Srx210 Services Gateway Using Chassis Alarm Conditions - Juniper SRX210 Series Manual

Related
Documentation

Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions

Copyright © 2012, Juniper Networks, Inc.
Table 44: Component LEDs on the Services Gateway (continued)
LED State
HA LED Off
Mini-PIM LED Green
Off
Monitoring the SRX210 Services Gateway Chassis Using the CLI on page 145
Monitoring the SRX210 Services Gateway Using Chassis Alarm Conditions on page 149
Monitoring the SRX210 Services Gateway Power System on page 152
Using the Reset Config Button on the SRX210 Services Gateway on page 153
Changing the Reset Config Button Behavior on the SRX210 Services Gateway on page 154
Juniper Networks Technical Assistance Center on page 155
When the services gateway detects an alarm condition, the alarm LED on the front panel
turns red or amber as appropriate.
To view a more detailed description of the cause of the alarm , issue the
CLI command.
alarms
For more information on the
Junos OS Initial Configuration Guide for Security Devices
Junos OS Monitoring and Troubleshooting Guide for Security Devices
Table 45 on page 150 describes alarms that can occur for an SRX210 Services Gateway
chassis component.
Chapter 20: Monitoring Hardware Components
Meaning
The Mini-PIM is present and
detected by the device.
The Mini-PIM is not present
or is not detected by the
device.
command, see the following guides:
show chassis alarms
Possible Causes and
Corrective Actions
The device is not part of the
chassis cluster setup.
Normal condition. No action
is required.
See "Monitoring the SRX210
Services Gateway Using
Chassis Alarm Conditions"
on page 149.
show chassis
149