Toshiba Strata DK 280 Installation Manual page 750

c
To Store the Voice Mail ID
Code:
1, Press a [PDN] or
[PhDN].
2. Enter # 6 5 6.
3. Enter 9 1.
4. Enter your mailbox
number.
5. Press RDL, then press
SPKR.
To Cancel the Voice Mail
I.D. Code:
1. Press the same [PDN]
or [PhDN] button that
was used to store the
Voice Mail I.D. Code.
2. Enter # 6 5 6.
3. Press RDL, then press
SPKR.
After you press the button, you will hear dial tone.
You will hear confirmation tone. The acceee code for setting the Voice Mail Call
Forward digit sequence is # 6 5 6. This code does not forward calls to the Voice
Mail system.
This could be the mailbox number for your [PDN], or if you press a [PhDN] in
Step 1, a unique (or the same) mailbox number for the [PhDN].
You will hear confirmation tone. The VM I.D. code will be automatically sent to
the Voice Mail system whenever calls are forwarded to it.
Note:
Steps 1 - 5 are required for the initial storage of VM I.D. code to the
Toshiba Voice Mail system. Once programmed, these digits remain in
memory until changed. Repeat Steps 1 - 5 to change fhe code.
You will hear dial tone after you press the button.
You will hear confirmation tone. The I.D. code will be cancelled.
76
To Forward Calls to the
Toshiba System:
1. Press the desired CF
button
or -
if you used an access
code sequence, press
a [PDN] or [PhDN],
then enter a Call
Forward access code
(shown on right).
2. Dial the Voice Mail
System Directory
number
3. PressCF
or
press SDS + RDL +
SPKR.
To Cancel Call Forward to
the Toshiba VP System:
I. Press the appropriate
Call Forward button
- or -
press a [PDN] or
[PhDN] + # 6 0 I,
then hang up.
Call Forward To Toshiba Voice Systems
By setting Call Forward to the Toshiba Voice Mail System on your telephone.
information about the call will automatically be sent to the Voice Mail system. so
that the callers who call your telephone and call forward to voice mail will be
automatically connected to your voice mail box.
The LED associated with the button will flash after you press the button.
Note:
"Call Forward" buttons apply only
to
[PDNs] and not to [PhDNs]. You
can set CaN Forward for both [PDNs] and [PhDNs]. but Call Forward
access codas must not be used for[PhDNs].
You will hear confirmation tone after entering the access code
Call Forward access codes:
Call Forward-A// Cak #601
Cd/ Forward-Busy: #602
Call Fofward-No Answer: #603
Call Forward-&w-No Answer: #604
See your System Administrator for the correct voice mail Directory Number. After
dialing, you will hear confirmation tone.
If your phone has a CF button assigned, its LED will light steady red.
The Call Forward LED will turn off, and Call Forward will be cancelled.
Note:
"Call Forward" buttons apply only
to
[PDNs] and "of fo [PhDNs].
You will hear confirmation tone, and Call Forward will be cancelled.
77