Toshiba Strata DK 280 Installation Manual page 588

Program *45-Z
- LCR/Toll Restriction Bypass for Special Numbers That Do Not
Begin with * or # Digits (R3)
SELECT = 1 - 6
DATA = 1 - 5 Digit Code (that are not subject to toll restriction)
First digit: 0 - 9 only
Non-First digits: 0 - 9, *, #
Button 01: Blank (end digit string)'
Button 02: Wild Card digit (any digit, 0 - 9)
SELECT = DATA = 1 - 5 DIGITS
Note:
1. The table shown above allows up to 5-digit numbers. If the number to be entered is less than 5 digits, enter Blanks
I (Button 0 1) for all digits less than 5 digits. See example b below where 8 17 is the data entered.
General Notes:
l
For more information, see the instructions preceding the record sheets.
l
When editing the data field, use Button/LED 01 to end the digit string, Button/LED 02 to assign a wild card value
(O- 9, *, #).
l
Initialized data leaves all data blank.
l
See Program 46 (10 * 80) Button/LED 04 should be OFF when dialing codes containing * and/or #.
l
This program option is provided with DK280, R3 Program 45, Dial Plan 7, 8, and 9 (only).
.
a. Use this program to allow special CO Area Codes and Centrex feature access codes or extension numbers to
bypass toll restrication and route over the local LCR route - if using LCR. (Toll Restriction will always be
'
applied after dialing the special numbers assigned to this table.
EXAMPLE:
If using LCR behind "assume 9" Centrex,and restricted stations (1 +AC not allowed) must dial 12XX# and
13XX# as Centrex station numbers (# is the Centrex suffix for extensions)
Enter:
mm- mb] and MRIBuffon MH as data in Programs *4!j-21 and *45-22,
respectively.
This will allow Centrex station numbers (1200# - 1299# and 1300# - 1399#) to de dialed - overriding Toll
Restriction.
b. Use this table to Toll Restrict and/or LCR route office codes in IO-digit dialing areas. If some non-toll numbers
require 1 O-digit dialing: Area Code (AC) + Office Code (OC) + YYYY dialing (no digit "I " before the area code)
enter the area code in this table if dialing through LCR. Area codes entered in this table (without the long
distance "1 "prefix) will be routed over the LCR local call route when dialed with the AC + OC + YYYY format.
EXAMPLE:
If area code 817 is a local area code that must be dialed without the prefix digit "1 ",
enter: @M[sl WOl) -1
in Program *45-2X. With this entry, LCR will route 817 calls over the local route after dialing: 817 XXX XXX.
10-174
February 1996