Toshiba Strata DK 280 Installation Manual page 565

Program 81 - 89 -
Ground/Loop Start/CO Line/Station Auto Attendant, Attendant
Console, and Distributed Hunt Group Ringing Assignments
(continued)
Program as follows for the above example.
1. Assign lines 00 1 * 005 to AA in Program 78-6 1.
2. Assign lines 001 m 005 to ring station 200 in Program 81.
3. Assign lines 001 m 005 to ring station 208 in Program 82.
4.
Assign lines 001 - 005 to ring any installed RSTU, PDKU, or PEKU port that has a telephone or
does not have a telephone connected in Program 83 (Program 83 assignment is used only to
I
enable Program 82 delay ring stations to ring. Assign [PhDN] 500 button on this port using
Program 39). :
5. Assign lines 00 I w 005 to flash [PhDN] 500 in Program W.
6. Assign the [PhDN] 500 button to station 200 and 208 using Program 39.
7. Using Program 39, assign [PhDN] button 500 on all station ports assigned to ring in Programs
I
81, 82, and 83.
Attendant Console Load Sharing
1. Assign all CO lines (ground, loop, and DID) that should alternately ring multiple attendant consoles to
the respective Load Share console ports in Programs 81, 84, and 87 (see example in Subsection
5.8.2 in Chapter 5-Station Apparatus of the DK280 I&M manual).
2. On DID lines, when the digits assigned to console ports in Program ti9 are dialed on incoming calls,
the calls will alternately ring the Load Share consoles.
February 1996
10-151