Station Apparatus; Types Of Telephones; Telephone Installation - Toshiba Strata DK 280 Installation Manual

Station Apparatus
This chapter provides instructions on how to connect
telephones to the Strata DK280 system and how to
configure and upgrade them for optional features.
Procedures for installing direct station selection
consoles, PC and conventional attendant consoles,
and door phones also appear in this chapter.
5.1 Types of Telephones
The Strata DK280 systems can support the following
telephones.
W Digital Telephones: Installation instructions for
digital telephones in this chapter and elsewhere in
this manual apply only to the Toshiba 2000- and
1 OOO-series digital telephones. The 2000-series
digital telephones consist of four models: the
DKT201 O-H, DKT201 O-SD, DKT2020-S, and
DKT2020-SD. There are two lOOO-series digital
telephone models, the DKT1020-H and DKT1020-
SD.
1 Electronic Telephones: The electronic telephone
instructions here apply to the Toshiba 6500-series
electronic telephones, although there are other
electronic telephones (the 2000-, 3000-, 6000-,
and 6500-series) that are compatible with the
Strata DK280. The 6500-series electronic
telephones consist of four models: the
EKT6510-H, EKT651 O-S, EKT6520-H, and
EKT6520-SD.
n Standard Telephones: 500- and 2500-type
standard telephones apply whenever standard
telephones are mentioned in this manual.
5.2 Telephone Installation
This section describes the wiring required to connect
telephones to the system. Before installing any
telephone wiring, read the following warning and
caution notes:
1.
2.
3.
4.
5.
WARNING !
Never install the telephone wiring
during a lightning storm.
Never install the telephone jacks in wet
locations, unless the jack is
specifically designed for wet
locations.
Never touch uninsulated telephone
wires or terminals unless the
telephone line has been disconnected
at the network interface.
Use caution when installing or
modifying telephone lines.
If telephone, DSS console, door phone
control box, or door phone wiring exits
the building, external secondary
protection is required. See Chapter 7-
Wiring Diagrams.
CAUTION !
When installing the station cable, do not run
the cables parallel if they are within three feet
of an AC power line. AC power lines should
be crossed at right (90") angles only. In
particular, avoid running station wire pairs
near devices that generate electrical noise,
such as neon or fluorescent light fixtures.
January 1996
5-1