Toshiba Strata DK 280 Installation Manual page 690

Table
13-l 4
Type 2 Programs: 17, 20, 30, *30,
31, *31, 35, 40, 41, *41-l, 43, 60-8, 79, 81 - 89
Step Action
Display/Printout
1
Enter Program Mode >MODE PROG
Atthe >MODE prOt?Ipt, type
P
R 0 G, press Enter.
P
2 Enter Program Number
P 30
Refer to the record sheet and enter the desired program number.
P30
Example: Program 30, type 3 0, press Enter.
3 Enter Port Number O0CiorPortRange UOO*c1CiCl
P30
Refer to the System Record Sheet and type the desired
P30 004
port number(s). Example: 0 0
4.
4 Press # key. P30 004#
5 Enter the Desired Button/LED Number
P30 004# 01
(or enter Data and go to Step 8)
Example: Button/LED 01, type: 0 1.
6 To Change Button/LED Status
P30 004# 01 N Y
Refer to the System Record Sheet and change the Button/LED
status, if required (Y or N).
Example: Type Y.
7 To Advance to Next Button/LED
Press Spacebar (repeat Step 6 if necessary).
8 To Store Data of Button/LED Status Change
PreSSEnter.
Repeat Steps 3 - 8 to review or change data.
pT T" c~~k!tE~F
9
To Exit Program/Store Data
PlO
A. To exit this program, press # #, then press Enter.
PlO ##
B. Continue returning to Step 2 until all Type 2 programs
P
are completed.
10 To Exit the Program Mode >MODE
Type # # and press Enter.
11
To Enter Another Mode,
Press:
DUMP
ENTER
(Data Dump) D
TEST
ENTER
(Test) T
MESG
ENTER
(LCD Messages) (no prompt)
REPT
ENTER
(Speed Dial) R
"KM' -.." .
Legena:
Y = button /LED(s) "ON';
N = button /LED(s) "OFF",
U = button /LED(s) "ON" some ports and "OFF" other ports.
January 1996
13-27