Toshiba Strata DK 280 Installation Manual page 589

Program *45-3 -
LCR/Toll Restriction Bypass for Special Numbers That Begin with *
or # Digits (R3)
l~lirin[rrillilnlrlR~-SpkrJR~R(-I-(SpkrjRn-nnrl-o-Hola-(~RRInolaFISpkr((iSl~l
SELECT=1 -9 -J- -r -r,,,,,,=,~,
DATA = Digit string
0 = No Toll Restriction after Special Code
(1 - 3 digits. Do not enter * or #)
1
= Toll Restriction after Special Code
Button 01 = blank (end digit string)'
2 = Special Code Restricted
Button 02 = Wild Card digit (any digit: 0 - 9)
SELECT = DATA =
OPTION =
DK0419
Note:
1. If the digit string is less than 3 digits, blanks must be entered in place of each digit less than 3 digits.
General Notes:
l
For more information, see the instructions preceding the record sheets.
l
When editing the data field, use Button/LED 01 to end the digit string, Button/LED 02 to assign
a wild card value (any digit: 0 B 9).
l
Initialized data leaves all data blank.
l
This program option is provided with DK280, R3, Program 45 Dial Plan 7, 8, and 9 only.
l
Use this program to allow special CO or Centrex access codes that begin with the * or # prefix. Assign them in
this table if it is required to bypass Toll Restriction and/or route over the local LCR route, if using LCR. (T.R.
options 0 N 2 will be applied after dialing the special numbers assigned in this table).
EXAMPLE 1:
If using LCR behind Centrex and you must dial Centrex
speed dial numbers +700- +799, enter: 14-1 IFI in Program *45-31. In this case, Toll
Restriction will not be appplied after the Centrex speed dial number (*7Xx) is sent to the Centrex because
Option "0" is set.
EXAMPLE 2:
If you are dialing out and you wish to block the Caller ID feature, you must dial * 67 or the appropriate provider's
code (e.g., *82, *85). In this case enter: m/?@%%%lw/ in Table *45-31. In this case the user dials *67 +
telephone number and Toll Restriction is applied to the telephone number after *67 is dialed because Option "1'
is set.
l
To allow * or # to be entered as a first digit, a number must be entered in at least onetable of Program *45-3X;
do not enter * and # as the first digit of any number in Program *45-3X; DK280 assumes the number entered in
this tab/e begins with a * or #I.
January 1996
10-175