Chapter Configuration - Toshiba Strata DK 280 Installation Manual

System Configuration can be complex and time consuming. For best results:
Use the software program 280Quote to provide easx fast, automated configuration. This
4
runs on an lBM compatible 486 PC, or higher, with a hard drive.
4 If the above software is not available, use all the Worksheets in Chapter I-Configuration.
Place the RCTU jumper plug(s) into battery position; otherwise, all programmed data will
1.
be lost upon power down. Battery jumper plugs are on: RCTUA, RCTUB, RCTUBA3,
RCTUC, and RCTUD3 PCBs.
2. Install RCCS PCBs on RCTU PCBs as required.
Install PDKU, PEKU, or RSlU in slot 11.
3.
If an RSlU is installed in slot 11, install a PDKU or PEKU in slot 12.
4. Starting with the lowest empty slot (S12 or S13), install all station, attendant console, loop
start, ground start, and RCIU/RCIS PCBs from lower to higher numbered slots (left to
right). Do not leave empty slots except when installing RDTU PCBs when required per
Tables 1-9 and 1-1
After all station, attendant console, and ground/loop start line, and RCIU/RCIS PCBs are *
5.
installed, install all DID and tie line PCBs starting from the first numbered empty slot to the
highest needed (in left to right order). Do not leave empty slots except when installing
RDTU PCBs per Tables 11 -1, 11 -2, and 11 -3 of Chapter 11 -T1.
Install PIOU, PIOUS, PEPU, or RSSU in any convenient vacant slot.
6.
7. Check power factors for each cabinet and for the entire system as explained
Chapter 1 -Configuration.
8. If needed, run Program 91-9 twice to initialize program data. Do this if you have just
completed Step 1 above. Run Program 03 and turn system power OFF (five seconds) and
then ON to activate and identify to Program 03 any subassembly PCBs installed.
9. Perform memory test as in Program 00, Part 2.
10. Program customer database manually or upload customer database using a 280Admin or
11. Backup the customer database using a 280Admin or 280Backup personal computer.
January 1996
IMPORTANT!
Important Installation Notes:
- and/or -
0 of Chapter 1-Configuration.
in