Toshiba Strata DK 280 Installation Manual page 743

c
Privacy Override
This optional feature allows you to enter an established call on a private common
CO button. Up to two station users may enter an existing CO line-to-station call
(allowing up to three stations to be connected to a CO line). To access this
feature, your station must be assigned with Privacy Override in system
programming, or the station that is already connected to the CO line must be in
the Privacy Release mode.
IMPORTANT I
Privacy Override only operates on common CO buttons; it will not
operate on common [DN] buttons which are a/ways private. See
'"Conference Calls" which aNow up to four Darties to talk on a lDN1
. _
To Override Privacy On-
line:
t Press a busy CO You will now be connected to the CO line and will be able to participate in the
button. conversation.
Connected parties may hear an optional tone signal before you enter the
conversation.
Note:
Station users with a PRV RLS button can allow stations to enter their
conversations on common CO buttons, even if the station entering the
conversation is not programmed for Privacy Override.
Privacy Release
If you press the optional PRV RLS button, any other station user can enter your
call on a private common CO button just by pressing the CO button on their
telephone. Your station must be assigned with this button in system
programming to activate this feat&a. Up to two stations can enter an existing CO
call (allowing up to three stations to be connected to a CO Ilne).
Note:
Privacy Release only applies to calls on common CO buttons; calls on
common (multi-appearing) [DN] button calls are always private and
cannot be accessed by more than one telephone, even if other
telephones share a common [DN].
62
To Activate Privacy Release:
l
While on a CO line call,
press PRV RLS.
To Deactivate Privacy
Release:
N Press PRV RLS
again.
To Release a Call and
Answer Another:
If you are on a call and a
new CO or [DN] call is
ringing at your station-
> Press the RLWANS
- or.
The PRV RLS LED will light steady red and the CO line will flash at all
appearances. Station users should be able to enter your calls by pressing a
common CO button. Only one station can enter each time PRV RLS is pressed.
You must be on a CO line call to activate this feature. The PRV RLS LED will turn
off when another station has entered your CO call.
The PRV RLS LED will turn off and station users without Privacy Override will
not be able to enter your calls by pressing a common CO. If you do not
deactivate PRV RLS while on the call, it will turn off when you hang up.
Note:
Private CO lines deny station users access to busy common CO
buttons.
Release and Answer
This feature enables you to automatically disconnect or transfer an active call
and answer a new call via the push of a button, instead of with the handset.
Notes:
1. This feature requires that you are currently connected to an existing
call.
2. Your telephone must have been programmed with both the PL and
the RLS/ANS button.
The PL or [DN] LED will flash red to indicate a new incoming call while you are
connected to the existing call. You will hear a muted, Busy Override or Camp-on-
busy tone.
Releases the original call and answers the new call. The PL LED will light steady.
63