Toshiba Strata DK 280 Installation Manual page 199

Program 58
H Attendant consoles one and two are connected to
58-I-Sets the attendant console overflow time
for each console.
RATU ports 024 and 025 respectively and should
load share 583-3700 calls and other CO line calls.
Program the DK280 as in (a) and (b) below:
58-2-Sets the Console Display for EL or CRT
(EGA) and enable or disable console call waiting
tone for each console.
(a)
(b)
58-4-Sets console answer key priority for each
console.
58-5-Sets the console overflow destination for
each console.
(c)
Program
59-Assigns Attendant Console Flexible
Buttons (Keys) for each console.
Distributing Incoming Calls (Console Load
Sharing) Between Multiple Attendant Consoles
Program 81
- 89-Assigns CO lines (loop, ground,
and DID) that should load share between individual
consoles on incoming calls. (tie lines load share on
Dial "0" calls only, without the use of Programs
81 - 89.) All incoming CO lines (including DID lines) to
be distributed between two or more attendant
consoles should be assigned to ring each console in
Programs 81 - 89.
Note:
Delay ring assignments do not apply to DID
lines.
Program
*09-Assigns the user's company's main
listed Directory Number
[DN]
(last four digits) to the
attendant console if DID lines should ring the console.
If the DID lines are assigned to ring multiple Attendant
Console ports in Programs 81 - 89, DID calls will be
distributed between the consoles. Only one console
(any one) should be assigned with the main listed
[DN] in Program *09.
Program
*I'/-Assigns each CO line to an attendant
console as the DID line intercept position as required.
(Intercept calls do not load share.)
Attendant Console Load Share Programming
Example:
i The user's company DID line [DN] is 583-3700;
this number and other loop start lines should ring
in a load sharing manner to each of the
Company's two Attendant Consoles in the Day,
Day 2, and Night modes.
In Programs 81, 84, and 87, assign all CO and
DID lines to ring ports 024 and 025.
In Program *81, *84 and *87, assign all CO
lines to flash the
[PDN]
of port 024.
In Program *09 or 71, assign digits 3700 to
port 024, and assign any other selected DID
extension number(s) to port 025-note that
when the DID extension number assigned to
either console is dialed, calls will load share
between consoles.
January 1996
5-21