Toshiba Strata DK 280 Installation Manual page 352

Table 8-5
Program 90 - Initializing Programs
00 - *99 (See Program 90 System Record Sheets)
Press...
Step Buttons + LED buttons
No. Action description
LCD RESPONSE . . .
1. Use the programming LCD electronic or digital telephone with
NO. 205
programming template connected to physical port 005 JAN 20 SUN
06:30
(station 205) - circuit 6.
2. *k#lk#1*2*3 PROGRAM MODE
Enter programming mode. (Do not press Intercom or
[DN]
button.)
3. Spkr (Speaker) 9 0 Hold PROGRAM = 90
Access Program 90. System beeps after Spkr (Speaker)
DATA STORE
is pressed indicating the program number can be entered.
4. Spkr (Speaker)
Prepare system for the programs to be initialized.
90 SELECT =
5. 0 0 * * 9 9 + LED keys 01 & 02
90 SELECT = 00**99
Enter program numbers individually, followed by #, or in a
DATA CLR
range. For a range, separate the low program number and
the high program number with an asterisk.
Note:
0 0 * * 9 9 will initialize all Programs 00 - *99.
Star "*'I Program memory follows Program 97.
6. Hold 90 SELECT = 00**99
Secure data in system programming. LEDs 01 and 02 flash.
DATA PROGRAMMED
7. Spkr (Speaker) 90 SELECT =
Prepare system for another selection (go back to
step 5), or exit Program 90 (continue with step 8).
8. # # Hold
Secure Program 90 data in system memory.
9. Spkr (Speaker)
Exit Program 90. Enter another program number (see
Table 8-6), or exit programming mode (go to step 10).
System beeps to indicate it's exiting Program 90.
90 SELECT = ##
DATA PROGRAMMED
PROGRAM =
0.
# # Hold
NO. 205
Exit programming mode.
JAN 20 SUN
06:42
Note:
The system will not allow the Spkr (Speaker)
LED to light to re-enter the programming mode.
IMPORTANT!
Always initialize Programs 00 - Jr99 when installing a Common Control Unit (RCTUA,
RCTUB, RCTUClD) for the first time for a particular configuration. This can also be done by
running Program 9 l-9.
I
.
8-12
January
1996