Toshiba Strata DK 280 Installation Manual page 722

c
To Answer While Idle (Tone
Signaling):
You will hear internal
ringing tone.
1, Lift the handset or
press SPKR and
speak to the
transferring station
2. You will be connected
to the transferred call
when the transferring
station hangs up.
To Answer While Idle
(Voice First Signaling):
You will hear a single long
tone, followed by the
caller's voice.
1. Talk in the direction of
your telephone
- or -
answer the call as you
normally would using
either the handset or
press SPKR to speak
to the caller
Answering a Transferred Call
You can answer a call that is transferred to your station, whether you are idle or
busy on another call.
Tone Signaling
The called button, [DN] or CO, LED will flash at the incoming call rate.
After you press SPKR. the LED will flash at the In-use rate.
The [DN] or Line LED will flash at the In-use rate and you will be connected to
the call.
Note:
If your telephone has been assigned with Ringing Line Preference in
system programming, you may press the ringing button or lift the
handset instead of pressing [DN] orC0.
Voice First Signaling
The called button LED will flash at the incoming call rate.
2. When the transferring
station hangs up, you
will hear ringing tone.
3. Press the flashing [DN]
or CO button.
To Answer an Incoming Call
While on Another Call:
You will hear a one second
warning tone. You can
choose Step A or B below:
You can place the call
on hold-
1. Press HOLD
2. Press the flashing
[DN] or CO
-or-
if your telephone
has the Auto Hold
feature, just press
the flashing [DN] 01
co
-or-
You can end the currenl
call and answer the
next by-
Pressing the ringing
[DN] or CO
-or-
Hanging up the current
call: the camped-on call
will ring your station.
Then press [DN] or CO
or lift the handset
The called button LED will flash at the incoming call rate
The [DN] or Line LED will flash at the In-use rate when the transferring station
hangs up.
Answer Call Waiting Calls
A warning tone indicates that another call is camped onto your station. The [DN]
or CO LED will flash at the on-hold rate.
The existing call will be put on hold. The camped-on line will ring your station
and the CO LED will flash red at the incoming call rate.
You will be connected to the transferred call and the [DN] or CO LED will flash at
the In-use rate.
With the Automatic Hold feature, the existing call placed on hold and you will be
connected to the transferred call. The [DN] or Line LED will flash at the In-use
rate. See your System Administrator to find out if you have Automatic Hold.
This will disconnect the current call and connect you to the transferred call and
the [DN] or Line LED will flash at the In-use rate.
The existing call will be disconnected. The camped-on line will ring your
telephone and the Line LED will flash red at the incoming call rate.