Toshiba Strata DK 280 Installation Manual page 576

Program 42 - 0
-CO Line to PBX/Centrex Connection (Lines 1 - 80)
Press:(Scroll( to advance or (/(to go back1
as defined by the table below. See Note 2
to change a CO line range.
Button
Set Button LEDs
Ir,-,-..,mqy
Nnrme,l
15
14
13
12
ll-
10
Notes:
DKO406
I
Set Button LEDs
C)..++r.. I I
CentrexlPBX
Connection (LED ON)
1 Normal 1
(LED OFF)
18
17 I 057 I
I
I
16
056
15 055
14 054
12 ---
01 1 041 1
1. To advance the CO line range, press the Scroll button beneath the LCD, press the Page button for a lower range.
2. To turn all CO LEDs on or
off, after
the
port number code
is
entered,
press the VolA (a/l LEDs on) or Volv (a// LEDs off).
To check a particular CO line, after the port number is entered, press Mode and enter the CO line number, then use the
# button to display and advance.
General Notes:
l
Initialized data reads all LEDs OFF for all CO lines.
.
This program must be utilized to allow Centrex/PBX (atier flash) features to operate.
.
If CO line is programmed for behind Centrex/PBX (LED ON), reseize guard time is 1.5 seconds. If CO line is programmed
for normal operation guard time is 0.45 seconds. See Program 10-1, Button/LED 02.
l
Do not use this program if installing DK 280 CO lines behind "assume-g" Centrex.
1 O-l 62
January 1996