8.2.3 Preparing The System For Programming; Chapter 9 - Record Sheet Instructions; Initialization And Test Programs - Toshiba Strata DK 280 Installation Manual

Record Sheet Instructions
-.
This chapter contains instructions on how fill out the
System Record Sheets in Chapter IO-Record
Sheets. Instructions appear in the same order for both
chapters:
Initialization and Test Programs
Basic System Records
Toll Restriction
Least Cost Routing
The System Record Sheets are used to record the
assignment of features or the operation of each
program. Each sheet provides space to record data.
This data will be referred to when programming the
system. The following consists of descriptions of each
of the programs available with the Strata DK280.
Initialized data information can be found in the Notes
at the bottom of each System Record Sheet.
9.1
Initialization and Test Programs
Use the programs in this section first before using the
other programs in this chapter.
Program 91-9 System Initialization
Always initialize a system with Program 91-9 when it is
first installed or when its software must be set to the
default configuration. Program 91-9 erases all random
or programmed data in all Strata DK280 software
programs and sets all program data to the default
value. Program 91-9 also automatically runs all other
initialization programs: 91-1, 90-00 - *99, 92-1 - 9.
CAUTION!
Program 91-9 will erase all program data and
it will drop all calls if it is run while the system
is in service.,
If only minor programming changes are being added
to a system in which the programming is basically
correct, skip this section.
To run Program 91-9:
1. Ensure that the system meets minimum hardware
requirements specified in Chapter 8-Section
8.2.3 Preparing the System for Programming.
2. Place the system power switch ON.
3.
Follow the steps in Table 8-3 and in the Program
91-9 record sheet.
IMPORTANT!
Release 3 and above: when installing
RCTlJ(s) for the first time, after initializing the
system, test the RAM: run Program 00-Part
2 (see 9.2-Basic System Records section of
this chapter). This test will drop all calls in
progress and will interrupt telephone service
for approximately 15 seconds. This test will
not erase programmed customer data.
Program 90-Initializing Programs
All customer data can be cleared and set to the
initialized state for any program or range of programs.
This program is normally used to initialize individual
programs. If the system is being installed for-the first
time, you must run Program 91-9 to cause this
program to erase random data from RAM which may
january 1996
9-1