Toshiba Strata DK 280 Installation Manual page 422

Program 00 -
Part 1: Software Check/Remote
Maintenance Security Code Assignments
SELECT = Select Code 2
Enter 0 to check software version.'
Enter 1 to change 1st level password.
Enter 2 to change 2nd level password.
Enter 8 to check software sum.
Enter 9 to check counter.
- Password Codes
Enter the 4-digit password.", 3
Select Code
Item Password or SAN Check Codes
0
ROM Version
= nnnnn See Note 1.
1
1st Level Password
= cloocl
2
8
2nd Level Password
= cl17cln
Software RAM Checksum
= nnnnnnnnr1 See Note 4.
9
Power Cycle Counter
= nnnnn See Note 4.
General Note:
l
See instructions in Table 8-8, Chapter 8-Programming Introduction to program the system with this information,
Notes:
1. This selection is not programmable. It identifies the system's software version as follows:
indicates RCTU
RaA3X
RCTU
C3/D3
I
KEYl= AA: Indicates built-in Auto Attendant software.
KEY2= ACD: indicates Automatic Call Distribution software and AA.
KEY3= ACD/MIS: Indicates Automatic Call Distribution, Management L
Information System Software, plus AA and ACD.
KEY4 = Open Architecture (OA) interface and AA, plus AA, ACD, and
A CD/MIS7.
2. Initialized passwords are 0000.
3. The LCD responds as follows, when a selection is made:
0 Version =
1 Password =
2 Password =
8
Sum=
9 Counter =
4. These selections are not programmable. They are for factory test purposes only. The Checksum and Counter vary
as customer data is entered.
5. The "3" in the RUA3X ROM identifier indicates DK280 Release 3 software; DK280 Release 1 and Release 2
ROMs are identified by
RUAX.
6. RKYS feature key must be installed on RCTU PCB to allow AA, ACD, ACD/MIS and Open Architecture (OA)
Interface software to be operational; no special program is necessary to activate the RKYS feature key.
:
7. Open Architecture (OA) is available with DK280 Release 3.2 and above.
I
1
O-6 February 1996