Toshiba Strata DK 280 Installation Manual page 747

.
To Chain Dial Speed Dial
Numbers:
Access a CO line.
Press the SDS button
(or *).
Press SDS and dial the
Speed Dial code for the
telephone number to be
dialed.
To dial another
telephone number.
press CONF and
repeat Steps 2 and 3.
Chain Dialing Speed Dial Numbers
You can call two or more Speed Dial numbers during one call. This enables you,
for example, to add additional parties (conference calls) to your conversation with
Speed Dialing.
See Appendix A-Table I-CO Line Access Codes.
Press + if your telephone does not have the SDS button.
Station Speed Dial codes are 1 0 - 4 9 and System Speed Dial codes are 6 0 0
-699or6O-99.
Two (Tandem) CO line Connection
Using a [DNI Button
This feature allows a station user to connect two CO lines, then drop out of the
conversation.
To Connect Two Outside
Lines (Using
a
IDNI
button):
1. While talking to an
external party on a
[DN] button, press
CONFITRNS.
2. Dial a CO line access
code and then the
external telephone
number of the other
party you want
connected.
After you press the button, you will hear dial tone, the [DN] LED will flash at the
conference rate.
See Appendix A-Table l-CO Line Access Codes. Ask your System
Administrator for the proper code to be used for this type of call.
70
3. Press CONFITRNS
after the party answers.
4. Press CONFITRNS
and hang-up.
To Connect Two Outside
Lines (Using a CO button):
1. While on a CO line call,
press CONFITRNS.
2. Press another CO
button and dial a
telephone number.
3. Press CONFIIRNS
after the party answers.
4. Press CONFITRNS.
5. Hang up
The [DN] LED will flash at the in-use rate and all parties will be conferenced.
If you receive a busy tone or no answer, return to the original connection by
pressing [DN]. You will hear dial tone and the [DN] LED will flash at the exclusive
hold rate after you press CONF/TRNS.
After you hang up. the [DN] LED will continue to flash at the exclusive hold rate
and the MO lines will be connected. The LED will turn off when the external
parties hang-up.
If the public telephone company provides auto disconnect. the connection may
release automatically when the parties hang up. If not, the lines must be
supervised to be disconnected (See "Supervision" following this procedure).
Using CO Buttons
This feature allows a station us?r to connect two CO lines, then drop out of the
conversation. Both CO buttons (or PL buttons) must appear on your telephone
to allow Tandem connections to be established from your telephone.
After you press the button, you will hear dial tone. the CO Line LED will flash at
the conference rate. The new Line LED will flash at the in-use rate.
The Line LEDs will both flash at the in-use rate and all parties will be
conferenced.
If you receive a busy tone or no answer. return to the original connection by
pressing the original Line button.
You will hear dial tone.
n The Line LEDs will both flash at the exclusive hold rate and the LED will
flash at the in-use rate.
n Both Line LEDs will continue to flash at the exclusive hold rate and the two
lines will be connected. The LED will turn off.
If the public telephone company provides auto disconnect. the connection may
release automatically when the parties hang up. If not. the lines must be
supervised to be disconnected (See the previous '"Supervision" instructions).
71