Toshiba Strata DK 280 Installation Manual page 347

Table 8-1
Simple Program: Program 33 - Station Hunting
Step
No.
1.
Action:
Buttons + LED buttons
Press
LCD RESPONSE . . .
Use the programming LCD electronic or digital telephone
NO. 205
connected to physical port 005 - circuit 6.
JAN 20 SUN
06:43
Make sure the programming button strip template is
installed on the programming telephone.
(See the Keystrip Template information in Section 8.2.2).
2. *#*#1*2*3
Enter programming mode. (Do not press
Intercom
or
[DN]
PROGRAM MODE
button.)
3.
Spkr (Speaker) 3 3 Hold
Access Program
33.
System beeps after
Spkr (Speaker) PROG- = 33
is pressed to indicate program number may be entered.
DATA STORE
4.
Spkr (Speaker)
Prepare the system for a station port selection.
33 SELECT =
5.
OOO#-239#
Select the port number of the Hunt From station. A 33 SELECT = (000 - 239)
range of ports can be entered as specified in on the
RUNT
TO
=
record sheet. After the Hunt From port is entered,
press the # button. Do not press # when entering a range.
6.
000-239
Enter the port number of the Hunt To point, as recorded
33 SELECT = (000 - 239)
on the system record sheet. Press LED button 01 to
HUNT
TO
= (000 -
239)
delete a digit from Hunt To point ports.
7.
8.
Hold
Secure data in system programming.
Spkr (Speaker)
Prepare system for another selection (go back to
Step 5), or exit Program 33 (continue with Step 9).
33 SELECT = (000 .. 239)
DATA PROGRAMMED
33 SELECT =
9. # # Hold
33 SELECT = ##
Secure Program 33 data in system memory.
DATA PROGRAMMED
10.
Spkr (Speaker)
PROGRAM =
Exit Program 33. Enter another program number or
exit programming mode (go to step 11).
Speaker beeps to indicate it is exiting Program 33.
11.
# # Hold
NO.
205
Exit programming mode.
JAN 20 SuIg
06.: 58
F.VM"f
E
-i
January 1996
8-7