Toshiba Strata DK 280 Installation Manual page 424

Program 01
- Station Logical Port Display and/or Change
To Save existing
r
Logical File: +iy
t- pqqq~-(-ISpkrlnnrI
SELECT = Enter Physical Pot-l Number
The logical port number associated with
the physical port will be displayed after
the physical port number is entered.
L
Enter new Logical Port
,
,
Program 02 -
Station Physical Port Display and/or Change
SELECT = Enter Logical Port Number
The physical port number associated
with the logical telephone port will be
displayed after the logical port number is
entered.
General Notes:
L
Enter new Physical Port
For more information, see the instructions preceding the record sheets.
Record port locations on Program 04 System Record Sheet.
Initialized data for Program 0 1 and 02 is logical port number = physical port number.
(Program 90, 9 1 - 1, or 9 l-9 will initialize Program 0 1 and 02.)
RCTU Station Ports for DK280 Release 1,2, and 3 are: RCTUA (000-031), RCTUB,
RCTUBA/BB, (000-079), and RCTUC/D (000-239).
The system allows only like ports to be reassigned (see below).
Allo wed:
l
Digital-to-Digital Ports (PDKU-PDKU-RDSU Potts)
l
Electronic-to-Electronic Ports (PEKU-PEKU-PESU Ports)
l
Standard Tel to Standard Tel Ports (PSTU-RSTU-PESU-RDSWRSTS)
Not Allowed:
l
Attendant Console, DSS, BGM or Amplified Conference Ports should not be
reassigned
l
Door Phone Ports (004, 012, 020, 028) should not be reassigned
l
Tie/DID Line Ports - should not be reassigned
l
PDKU fo PEKU - cannot be exchanged
l
PSTU fo PDKU - cannot be exchanged
l
PEKU to PSTU - cannot be exchanged
I
RCIWRCIS circuit assignments to CO lines are not affected by Program 01 and 02.
OK0087
1 O-8
January 1996