Directory Number Programming - Toshiba Strata DK 280 Installation Manual

,
Program 39 -
Directory Number Assignments (continued)
Table 10-3
Directory Number Programming
Directory Number [DN] Type Maximum [DN] Buttons
on a Telephone
Maximum System [DN] Button Maximum [DN] Numbers
Appearances
per system
Primary Directory Number
[PDN]:
Up to 4 [PDN] buttons per A Primary Directory Number can
[PDNs] are defined in
One
[DN]
is assigned to each Telephone port
owner telephone. appear as a [PDN] button on the
Program 04.
in Program 04; this [DN] is designated as the [PDN] buttons are
[PDN]
owner telephone only;
[PDN]
of that telephone. The telephone is assigned in Program 39.
however, any Primary Directory
RCTUA = 32
[PDNs]
designated as the
[PDN]
owner.
Number can appear as an [SDN] RCTUBAfBB = 8O [PDNs]
button on all Toshiba telephones
in the system. A [PDN]/[SDN]
RCTUC3/D3 = 240
[PDNs]
button is limited to ring on 120
telephones, maximum.
Secondary Directory Number [SDN] : Four of the same
[SDN]
Any Primary Directory Number
[SDN]
buttons are Primary Directory Numbers
button per te'ephone.
can appear as an [SDN] button
Note: [PDNs] and
[SDNs]
,are actually
the same
that appear on telephones other than the 16
[PDN]
and
[SDN]
on all Toshiba telephones in the
numbers.
[PDN] owner telephone. buttons per telephone
system but a [PDN]/[SDN] button
combined, maximum.
is limited to ring on 120
[SDN] buttons are
telephones maximum.
assigned in Program 39.
Phantom Directory Number [PhDN]: One of the same [PhDN]
Any [PhDN] button can appear
button per telephone.
[PhDNs]
are defined in
240 [PhDNs]
are defined in Program *04,
on all Toshiba telephones in the
Program *04
[PhDNs]
must be assigned to owner Eight different
[PhDN]
system but an [PhDN] button is
telephones in Program *33. Default buttons per telephone.
limited to ring on 120 telephones
RCTUA
= 32 [PhDNs]
programming assigns no telephones as
maximum.
RCTUBAIBB
= 80 [PhDNs]
[PhDN]
owner telephones (see Note 3 below).
[PhDN] buttons
are
assigned in program 39,
RCTUCS/D3 = 240 [PhDNs]
General Notes:
DK0226
l
The
total number of
[DNs]
a//owed on a telephone
fiPDN] , [SDNs] , and[PhDNs]) is
limited to the number of buttons on the telephone (i.e.,
a 20-button telephone can have 20
[DN]
buttons with any combination that meets the above Table A criteria).
.
The total number of actual unique directory numbers in Strata DK280 Release 3 RCTUC/D, is
240 [PDNs] + 240 [PhDNs] = 480 [DNs];
[SDN]
buttons are actually
[PDNs]
that appear on felephones other than the
[PDNs]
owner telephone.
l
Phantom
[DN]
owner telephones have the following attributes:
l
Sef Call
Forward for
[PhDNs]
l
Set Call Forward Mail Box destinations (VM ID codes) for [PhDNs]
l
Receive Message Waiting indication for up to four Phantom Directory Numbers on individual [PhDNIMW] button LEDs
.
When off-hook, the
[PhDN]
telephone owner will receive OCA calls directed to a busy the [PhDN].
l
The number of
[SDN]
buttons programmed on a telephone for a given Primary Directory Number must a/ways be the same as
the number of [PDN] buttons that exist on the
[PDN]
Owner telephone. Example: If [PDN] 200 appears on 3 buttons on station
200, and
[SDN]
200 should appear on station 207, then [SDNI 200 must appear on 3-butfons on station 201. Never put more
(or less)
[SDN]
buttons of the same Directory Number on a telephone than
[PDN]
buttons that appear on the [PDN] owner
telephone. If this guideline is not followed, calls to the [PDN] telephone will be missed on the [SDN] telephone.
l
[PDN] and/or [PhDN] Cal/ Forward/Message retrieval can on/y be set/received
ffOm
the [PDN] and/or [PhDN] owner telephone.
.
To assign ground/loop start lines to ring
[DNs],
use Program 81 - 88 to assign the
[DN]'s
telephone to ring and Program
*87, *84,agd *87 to assign the [DN] button LED to f/ash (I Hz) on the telephone when the CO line rings. Do not assign use
Program *81, *84,and *87 to assign
[DNs]
to f/ash on incoming CO line calls if the incoming CO line buttons appear on the
telephone - this will cause more than one button to flash when the CO line rings the telephone. See "IMPORTANT" below.
l
To assign a [DN] to ring when called from another
[DN],
a tie line, or DID line; use Programs *71, *72, and *73 to assign the
'telephone(s) on which the
[DN]
button appears to ring. Also use Programs *09 or 71-1 (I - 3) to assign the Primary or
Phantom [DN] to ring for D/D, DNIS, and AN/ calls.
1
.i
IMPORTANT!
Only 120 telephones, maximum can be programmed to ring when a CO line, [PDN]/tSDN],,of [PhDN] is called.
l
Do not assign DID, tie, DNIS, or AN/ lines to CO or pooled line button appearances on telephones because these types of
lines will cause the telephone
[PDN] , [SDN],
or
[PhDNl
to f/ash and ring when the line rings. If a D/D/tie line button appears on
a telephone, the telephone
[DN]
button and the tie/DID line (or pooled line) button will f/ash when the tie or DID line rings the
telephone. This could be confusing to the telephone user.
1 O-76
January 1996