Toshiba Strata DK 280 Installation Manual page 740

To change from
speakerphone to handset:
w Lift handset.
Microphone Control Microphone Cut-Off
If you have a speakerphone, press the MIC button to switch the microphone on
and off while your telephone is in use (see Microphone Cut-off). The MIC LED
indicates the status of the microphone:
To Turn the Microphone
Off/On:
Microphone Cut-off prevents callers from monitoring the sounds near your
telephone when your telephone receives a Handsfree Call. Your station must be
assigned with the MC0 button in system programming to activate this feature.
LED
09°F
MICROPHONE
09°F
l Press MC0 to toggle
When you turn the microphone off, the MC0 LED will light steady red and the
between off and on. MIC and SPKR LEDs will not turn on when your telephone is being called. When
the microphone is turned on, the MC0 LED will turn off.
TO change from handset to
speakerphone:
1. Press and hold down
SPKR.
2. Return handset
on-hook.
3. Release SPKR.
All electronic telephone users can arwver internal calls handsfree (on-hook), but
only users with a speakerphone can talk handsfree when originating calls while
on-hook.
The microphone and accompanying LED are always on when receiving internal
[DN] calls to allow Handsfree Answerback and may be on or off when placing an
on-hook CO line or internal [DN] call.
1 Each station's microphone may be set in system programming to be either
on or off at the start of handsfree dialing.
n Each station's MIC button may be set in system programming to switch
on/off with one touch or to switch off only while pressed and held.
Note:
The MIC and MC0 buttons function on Handsfree Answerback and
Off-hook Call Announce m//s for privacy.
Night Transfer
Incoming calls to your system can be made to route and ring different
destinations depending on which ring mode is set using the NT button. The NT
button can be locked into any mode by dialing the Night Transfer lock password.
Your system can operate with two or three call routing (ringing) patterns. Three
routing pattern systems feature the Day, Day 2. and Night modes, while two-
ringing pattern systems consist of the Day and.Night modes. These ringing
patterns are chosen by pressing the optional NT button, assigned in system
programming.
The Night Transfer LED indicates the active routing pattern. as follows:
Three-pattern Two pattern
DAY OFF OFF
DAY 2 FLASH
N/A
NIGHT ON ON
56
57