5.2.4 Telephone Wall Mounting; Digital Telephone Upgrades; Handset Hanger - Toshiba Strata DK 280 Installation Manual

off-premises via the telephone network should
interface with OL13A, OL13B, or OL13C lines (or
equivalent) and connect to an RJ21X, FIC jack or
equivalent, (see Chapter 7-Wiring Diagrams, Table
7-3).
5.2.4 Telephone Wall Mounting
This section provides instructions on how to mount
digital telephones and electronic telephones to a wall
or other vertical surface. Instructions on mounting
standard telephones are not provided here; refer to
the manufacturer's documentation for those
instructions.
,
Mount digital and electronic telephones in accordance
with the following steps:
Notes:
1. Digital telephones equipped with
Integrated Data In tetface Units (PDIU- Dls,
RPCI-Dls or PDIU-Dl2s) cannot be wall
mounted.
2. Electronic and older digital telephones
equipped with an HHEUl can be wall
mounted. 2000-series digital telephones
with headsets can only be wall mounted
with an HHEU2.
1. Loosen the captive screws, and remove the
telephone base (Figure 5-l).
2. Using a suitable cutter, remove the handset
hanger from the base (Figure 5-l). Insert the
handset hanger in the slot provided on the front of
the telephone (Figure 5-2). The hanger fits in the
notch on the handset cradle.
3. Rotate the telephone base 180 degrees and
secure it to the telephone with its four captive
screws (Figure 5-3).
4. Connect the telephone to the wall modular
connector with a cord approximately four inches
long (available at most telephone supply
companies). Route the cord into the hollow portion
of the base.
5. Mount the telephone on the wall mounting
modular connector plate.
5.3 Digital Telephone Upgrades
This section describes how to upgrade and configure
2000- and lOOO-series digital telephones for features
and options.
HANDSET
HANGER
PLASTIC
TAB
DK0060
Figure 5-l
Removing the Telephone Base
HANDSET
HANGER
%
Figure 5-2
Handset Hanger
DK0061
January 1996
5-3